MACHINE INSTALLATION 17 January, 2003
1-8
1.4 MACHINE INSTALLATION
Refer to the Operating Instructions. If the customer has made a service contract,
change the settings of the following SP mode menus in accordance with it.
NOTE: 1) The meter charge mode must be enabled for any meter click counter
contract (☛ SP5-930-1).
2) One of the counter methods (developments/prints) must be selected in
accordance with the contract (☛ SP5-045-1).
3) The default of the meter-charge mode is "off."
4) The meter-charge counter cannot be reset.
Item SP No. Function Default
Meter
charge
SP5-930-1 Specifies whether the meter charge mode is
enabled or disabled.
Meter charge mode enabled:
• The Counter menu appears immediately
after the Menu key is pressed.
• The counter type selected by the counting
method (SP5-045-1) can be displayed with
the Counter menu.
• The counter values can also be printed with
the Counter menu.
• The selected counter starts from a negative
number.
• When the ACS mode is on, a monochrome
page is counted as such even if it follows a
color page.
Meter charge mode disabled:
• The Counter menu is not displayed.
• The total counter starts from 0.
• When the ACS mode is on, a monochrome
page is counted as a color page if it follows
a color page.
NOTE: The menu items, "Show Counter" and
"Print," appear in the UP mode after
the meter charge mode (SP5-930-1) is
enabled or the optional CF expander
is installed. (These menu items
always appear after the CF expander
is installed.)
"OFF"
Counting
method
SP5-045-1 Specifies whether the counting method used
in meter charge mode is based on
developments or prints.
Important:
This SP can only be done before the negative
counters are reset with SP7-825-001.
"0":
Developments
A3/11" x 17"
double
counting
SP5-104-1 Specifies whether the counter is doubled for
A3/11" x 17" paper.
"No": Single
counting
To Next Page
Loading...
