Ricoh J-P2 - Development Motor - Cmy

17 January, 2003 DRIVE UNIT
3-51
Replacement
Adjustment
3.11.3 DEVELOPMENT MOTOR - CMY
1. Rear cover (☛ 3.3)
2. Swing out the controller box (☛ 3.10.1).
3. Drum gear cover [A] (" x 2, ! x 5)
4. Turn the drum gears [B] counterclockwise, so the shoulder screws [C][D] are in
the three, seven, or eleven o'clock position.
NOTE: By doing that, you can align the three corners of each drum-gear shaft to
the three openings on the development-clutch securing plate [E].
G080R746.WMF
G080R747.WMF
[A]
[B]
[C]
[D]
[E]