17 January, 2003 SERVICE PROGRAM MODE – CF CONFIGURATION
5-5
Service
Tables
5.2 SERVICE PROGRAM MODE – CF CONFIGURATION
!
CAUTION
Before accessing the service menu, do the following:
Confirm that there is no print data in the printer buffer (the Data In LED
must not be lit or blinking).
If there is some data in the buffer, wait until all data has been printed.
5.2.1 ENABLING AND DISABLING SERVICE PROGRAM MODE
Entering SP Mode
"#
1. Press the Clear Mode key.
$%&#
2. Use the keypad to enter “107”.
'#
3. Hold down Clear/Stop for at least 3 seconds.
4. Enter the Service Mode.
Exiting SP Mode
Exit 5. Press Exit twice to return to the copy window.
5.2.2 TYPES OF SP MODES
Copy SP SP modes related to the engine functions
Printer SP SP modes related to the controller functions
Scanner SP SP modes related to the scanner functions
Fax SP SP modes related to the fax functions
After accessing the SP mode, select one of the Service Program modes (Copy,
Printer, Scanner, or Fax) from the touch panel as shown in the diagram below.
This section explains the functions of the Printer/Copy/Scanner SP modes. Please
refer to the Fax service manual for the Fax SP modes.
G080S905.WMF
To Next Page
Loading...
