17 January, 2003 OPTIONAL UNIT INSTALLATION
1-23
Installation
6. Attach the right bridging bracket [A] to the rack’s right stand
(2 screws [B]).
7. Attach the left bridging bracket [C] to the lower left corner of the paper feed unit
(2 stepped screws [D], 2 spring washers [E] and 2 washers [F]).
8. Insert the printer in between the racks as shown and set it to the desired
position.
9. Secure the right bridging bracket [A] to the paper feed unit (2 stepped screws
[G], 2 spring washers [H] and 2 washers [I]).
10. Secure the left bridging bracket [C] to the rack’s left stand (! x 2 [J]).
11. Remove the mailbox upper cover
[K]. With a pair of pliers, remove
the small square cutout [L] in the
corner of the cover with a pair of
pliers.
Then, set the grounding bracket
[M] in the machine as shown and
reattach the upper cover.
G367I206.WMF
G367I217.WMF
[K]
[M]
[L]
[C]
[A]
[B]
[D]
[G]
[J]
[E]
[F]
[H]
[I]
To Next Page
Loading...
