Ricoh J-P2 - Transfer and Paper Transport Unit; Transfer Unit

17 January, 2003 TRANSFER AND PAPER TRANSPORT UNIT
3-21
Replacement
Adjustment
3.7 TRANSFER AND PAPER TRANSPORT UNIT
3.7.1 TRANSFER UNIT
NOTE: 1) When removing or installing the transfer unit, grasp the central areas of
the front and rear frame. Do not touch the transfer belt [A]. Do not
damage the entrance mylar [B].
2) Remove the duplex feed unit (if it is installed) before replacing the
transfer unit.
3) After replacing the transfer unit, reset the maintenance counter, SP7-
804-16, and conduct the output check, SP5-804-74.
1. Turn the release lever counterclockwise. (☛ 3.5)
2. Pull out the transfer unit [C] until the entire unit is visible (! x 2).
3. Grasp the transfer unit grips as shown above. Lift the unit to remove it.
NOTE: Grasp the front grip. Use caution not to damage the actuator on the rear.
After replacing the transfer unit:
• Perform forced line position adjustment (SP5-993-002 or “Maintenance menu –
Color Registration - Auto Adjust” in User Program mode).
• Print the 1-dot grid pattern on A3/11" x 17" paper and check the color shift level
(☛ 4.4.3).
G080R737.WMF
[A]
[C]
[B]