Ricoh J-P2 - Electrical Components; Moving the Controller Box out of the Way; Moving the High Voltage Supply Unit - C, B out of the Way

17 January, 2003 ELECTRICAL COMPONENTS
3-43
Replacement
Adjustment
3.10 ELECTRICAL COMPONENTS
3.10.1 MOVING THE CONTROLLER BOX OUT OF THE WAY
1. Rear cover (☛ 3.3)
2. Connector cover [A] (! x 1)
3. Four flat cables [B]
4. Connector [C]
5. Swing out the controller box [D] (! x 4).
NOTE: When the controller box is swung out, free-run tests can still be done.
However, because the LD cables are disconnected, no output appears.
3.10.2 MOVING THE HIGH VOLTAGE SUPPLY UNIT - C, B OUT
OF THE WAY
1. Rear cover (☛ 3.3)
2. Swing out the high voltage supply unit
[A] (! x 2).
G080R935.WMF
G080R936.WMF
G080R937.WMF
[B]
[C]
[A]
[D]
[A]