Ricoh J-P2 - Preventive Maintenance; User Maintenance

17 January, 2003 USER MAINTENANCE
2-1
Preventive
Maintenance
2. PREVENTIVE MAINTENANCE
2.1 USER MAINTENANCE
The following maintenance kits are available for the customer to do PM.
Type A Color (C/M/Y) PCU 50KP
Type B Color (C/M/Y) Development Unit 100KP
Type C Fusing Unit 100KP
Type D Black Development Unit / Dust Filter 100KP
Type E Waste Toner Bottle 50KP
Type F Black PCU 50KP
Type G Oil Supply Unit 30KP
Type H Paper Feed Rollers 150KP
Chart: A4 (LT)/5%
Mode: 5 prints/job
Environment: Normal temperature and humidity
Yield may change depending on circumstances and print conditions.
When the machine’s default settings are used, an error message is displayed when
a maintenance counter reaches the value in the PM table below, except for the
items in maintenance kit H.
NOTE: To have the machine display the message for maintenance kit H also, set
SP5-930-4 to 1.
After the user replaces the items in a maintenance kit, the machine automatically
resets the counter for this maintenance kit, except for the items in kit H.
NOTE: Except for the items in kit H, the machine can automatically detect when
new items have been installed.
The machine stops when the counters for parts in maintenance kits E and G reach
the replacement value in the following table.
NOTE: To have the machine display the alert only for maintenance kits E and G,
set SP5-930-3 to 0.