PRINTER ENGINE SERVICE MODE 17 January, 2003
5-54
5
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[Finisher Stack] Finisher Maximum Stack
961
1 Finisher Stack *BCU
#
Enables or disables maximum stack mode for the
lower shift tray only in staple mode.
If this is enabled, the upper tray can be
used for stacking 500 sheets but it stays
at the upper exit (will not be used for
stapling mode), and the lower tray is used
for stacking up to 2,000 sheets.
If this is disabled, the upper tray can be used for
stacking 500 sheets and the lower tray for 1,500
sheets.
[ 0 or 1 / 1
/ - ]
0: Disabled
1: Enabled
NOTE: The main switch must be turned off and on
to effect the setting change.
[DebugSerial]
970
1 DebugSerial *CTL [0 ~ 0xff / 0x00 / 0 /step] DFU
[Touch Panel Correction] Touch Panel Correction Log
971
1 Touch Panel Calibration *
CTL
CF
Displays whether the touch panel has been
calibrated after clearing all memory.
[ 0 or 1 / 0
/ - ]
0: Not calibrated
1: Calibrated
[Cherry Server Setting}
974
1 Cherry Server Setting *
CTL
CF
Specifies which version of ScanRouter, “Lite” or
“Full”, is installed.
[ 0 or 1 / 0
/ - ]
0: Lite
1: Full
[CSS Setup Call]
981
1 CSS Setup Call
DFU
[Loop Back Test]
1 Duplex
3 Finisher
989
4 PSU
Executes a communication test with peripherals
by using a special tool (connector) which is unique
for each peripheral.
The machine checks if the communication with the
peripherals is OK or NG; then displays the result.
DFU
[SP print mode]
1 SP all print
2 All
3 User Program CF
4 Logging
990
5 Diagnosis Report CF
Prints out the SMC sheets.
6 Non-Default
7 NIB Summary
8 Net File Log CF
21 Copier User Program CF
22 Scanner SP CF
990
23 Scanner User Program
CF
Prints out the SMC sheets.
To Next Page
Loading...
