17 January, 2003 PRINTER ENGINE SERVICE MODE
5-61
Service
Tables
6
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[DF Magnification Adj.] DF Magnification Adjustment
017
1 DF Magnification Adj. *
NV
CF
Adjusts the magnification in the sub-scan direction
for the ARDF.
[ -5.0 to 5.0 / 0
/ 0.1 %/step ]
[Punch] Punch Positioning
1 Punch 1 *BCU
110
2 Punch 2 *BCU
Adjusts the punching position.
Punch 1
US: 2 punch holes
Europe: 2 punch holes
North Europe: 4 punch holes
Punch 2
US: 3 punch holes
Europe: 4 punch holes
Increment: Holes move toward the paper center.
Decrement: Holes move toward the paper edge.
[ -7.5 to 7.5 / 0 / 0.5 mm/step ]
[Staple] Staple Position
111
1 Staple *BCU Adjusts the stapling position.
Increment: Staple position moves toward the edge
of paper.
Decrement: Staple position moves toward the
center of paper.
[ -3.5 to 3.5 / 0
/ 0.5 mm/step ]
NOTE: Although the adjustable range is ±3.5 mm,
the stapling position can be changed only by 1.0
mm when stapling one position at the front or rear
side even when the input value is more than 1.0.
[Multi Bin Set]
901
1 Multi Bin Set *
BCU
CF
Specifies whether or not the optional multi-bin
output tray is installed. When installing the multi-
bin output tray, this SP mode should be set to “1”.
[ 0 or 1 / 0 / - ]
0: Not installed
1: Installed
To Next Page
Loading...
