17 January, 2003 OPTIONAL UNIT INSTALLATION
1-21
Installation
5. Set the table board [A] on the stand as shown.
NOTE: 1) Make sure that the screw holes for the scanner unit are positioned
at the right rear [C] and left front [B] of the table board.
2) Recommended attachment positions for the table board:
• Machine with Two-tray Paper Supply Unit & LCT: 2nd hole from
the top
• Machine with One-tray Paper Supply Unit: 6th hole from the top
3) When attaching the table board at a position lower than the
recommended one, make sure the upper right cover can be opened
and the toner cartridges (especially black) can be replaced.
When attaching the table board below the recommended position, it
is necessary to shift the printer mainframe 10 cm (3.9") toward the
front so that the upper right cover can be opened for toner
replenishment.
6. Align the cushion [D] (enclosed as accessories for the optional CF Expander)
as follows and attach it to the backboard [E]:
• Align the top side with the bottom end of the lowermost slot of the right side
stand [F].
• Align the right side with the left side of the right side stand [G].
NOTE: The cushion prevents the right side stand [I] from damaging the
scanner cable [H]. The cushion can be ineffective if attached to an
incorrect position.
G367I103.WMF
G367I903.WMF
[A]
[D]
[E]
[F]
[G]
[C]
[H] [I]
[B]
To Next Page
Loading...
