17 January, 2003 OPTIONAL UNIT INSTALLATION
1-25
Installation
2. Replace the printer module [A] in the upper slot with DIMM #1 (SYSTEM) [B].
3. Insert DIMM #2 (PRT/SCN) [C] into the center slot.
4. Insert the 128MB memory [D].
NOTE: 1) It is not necessary to install the additional memory if the present
memory is 192MB or more.
2) Make sure that the modules are firmly set in their slots. If they are
not, this will cause SC997.
5. Attach the NVRAM board [E] (! x 1).
NOTE: 1) It is not necessary to install this NVRAM board in machines that
already contain the optional User Account Enhancement Unit Type
C.
2) If replacing the Unit Type C with the NVRAM board, be sure to back
up and re-enter the User Code data using SmartNetMonitor for
Admin.
G367I205.WMF
G367I701.WMF
[E]
[C]
[A]
[B]
[D]
[B]
[C]
To Next Page
Loading...
