OPTIONAL UNIT INSTALLATION 17 January, 2003
1-38
6. Install the front [A] and rear [B] tray
holders on the top cover (! x 2 for
each).
7. Install the upper [C] and lower [D] trays.
8. Turn the main switch on; select the SP
mode menu, SP6ā901ā1; and change
the multi-bin output tray setting.
NOTE: The multi-bin output tray is not
automatically recognized by the
printer mainframe. The multi-bin
output tray cannot be used until
you have changed this SP mode
setting.
G306I103.WMF
[A]
[B]
[D]
[C]
To Next Page
Loading...
