SC Error Codes
J012/J013/J014 4-32 SM
Jam 7 PFU Paper Transport Jam
Message: Paper Misfeed: Guide Plate
Jam
A paper lag jam occurred when feeding paper from the PFU. The trailing
edge sensor detected the leading edge of the paper but not the trailing
edge because the paper stopped at the trailing edge sensor.
Cause:
Double-feed
Incorrect paper detection due to dirt or obstruction on the transfer belt
No signal from trailing edge sensor
Trailing edge sensor feeler positioned incorrectly
Problem Site
Transfer belt unit
Trailing edge sensor
Action
Perform check, take action in this order:
1. Clean the transport belt.
2. Replace the trailing edge sensor.
3. Replace the PFU.
Jam 8 Multi Bypass Tray Exit Jam
Message: Paper Misfeed: Bypass Tray
Jam
A paper lag jam occurred during paper feed from the Multi Bypass Tray.
After the 2nd Registration sensor detected the leading edge of the paper, it
failed to detect the trailing edge because the paper stopped.
Cause:
The 2nd Registration sensor failed to signal detection of the trailing
edge of the paper.
Problem Site 2nd Registration sensor
Action
Perform check, take action in this order:
1. Replace 2nd Registration sensor.
2. Replace CTL board.
Jam 9 Paper Jam from Tray 1 Between TE Sensor and Registration Sensors
To Next Page
Loading...
