Ricoh J012 - Page 201

SC Error Codes
SM 4-35 J012/J013/J014
Trouble-
shooting
Jam 12 Initial Jam
Message: Paper Misfeed: Inverter Guide Plate
Jam
The trailing edge sensor switches ON when the printer is switched on or
while printer is initializing.
Cause:
 The trailing edge sensor does not change (go OFF).
 Paper feed clutch remains ON.
Problem Site
 Trailing edge sensor
 Paper feed clutch
Action
Perform check, take action in this order:
1. Clean the transfer belt.
2. Replace inverter guide plate.
3. Replace trailing edge sensor.
4. Replace 1st Registration sensor.
5. Replace 2nd Registration sensor.
6. Replace CTL board.
Jam 14 Carriage Jam
Message: Ppr Misfd: Scan.Unit
Jam
The carriage was prevented from reaching its target position within the
prescribed time.
Cause:
 A piece of paper or other object is obstructing the movement of the
carriage.
 A piece of paper or other object is obstructing the paper path.
 The horizontal film encoder is dirty, slack, buckled, or damaged.
 Horizontal feed motor belt is loose or broken.
Problem Site
 Horizontal encoder film strip
 Horizontal feed motor belt
 CTL board
Action Perform check, take action in this order:
⇒
Rev. 01/2008
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA