Message Causes Solutions
Open Front Cover
then move Envelope
Lever up/down.
The fusing unit levers are not
positioned correctly.
The machine can start printing only if the
fusing unit levers are in the correct
positions for the paper type.
• To print on an envelope, open the
front cover, and then lower the left
and right levers to the envelope mark.
• To print on paper, open the front
cover, and then raise the left and right
levers to the plain paper mark.
Out of Paper: X The indicated tray has run out of
paper.
Load paper to the indicated tray. See
page 50 "Loading Paper".
Please Restart
Machine
The machine needs to be
restarted.
Turn off the power, and then turn it back
on.
Remove Paper:
Bypass Tray
The machine failed to proceed
with the print job, because tray
1 or Tray 2 was specified as the
input tray but paper was set in
the bypass tray.
Remove paper from the bypass tray.
Replace Intermediate
Transfer Belt
The transfer belt is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replace Required
Soon:
Toner Cartridge (X)
The print cartridge is almost
empty.
Prepare a new print cartridge.
Replace Required
Soon:
Waste Toner Bottle
The waste toner bottle needs to
be replaced soon.
Prepare a new waste toner bottle.
Replacement
Required:
Fusing Unit
The fusing unit is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replacement
Required:
Paper Feed Roller
The paper feed roller is no
longer usable, and must be
replaced.
Contact your sales or service
representative.
Error and Status Messages on the Screen
349
To Next Page
Loading...
