Technical Bulletin PAGE: 4/4
Model: Taurus-C1a/C1b (D074/D075) Date: 21-May-12 No.: RD074069
4. Check to make sure that the spring plate has been attached to the correct position,
directly above the center hole.
¾ If the position needs to be adjusted, carefully slide the spring plate without
detaching it from the case. When doing so, hold the flat surfaces to prevent
cutting your fingers with the sharp edges.
5. Reattach the filter to complete the procedure.
Note: If the spring plate is not locked in place correctly, you may use a flathead precision
screwdriver to lift up the black case.
[A]
To Next Page
Loading...
