Technical Bulletin PAGE: 1/5
Model: Taurus-C1a/C1b (D074/D075) Date: 1-Oct-13 No.: RD074109
Subject: Notes on installing PU5020 (D449) on
SR5030/SR5040 (D513/512)
Prepared by: Shinnosuke Sasaki
From: 1st PP Tech Service Sec., PP Tech Service Dept.,
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Classification:
Product Safety Other ( ) Tier 2
General
As a result of changes to the product design implemented in Dec 2012, the Punch Unit
PU5020 now has two types of brackets; old and new.
Brackets of the old type cannot be attached to finishers manufactured since Dec 2012.
Please make sure to take with you the new bracket when visiting a customer site to install
the punch unit. See the following pages for how to replace the old bracket with the new
bracket.
Please contact your supervisor to procure the new bracket.
* Sufficient quantities of brackets are supplied to all regions free of charge.
Old bracket:
Cannot be used on new finishers.
New bracket: Can be used on old and new finishers.
The following table shows the punch units installed with the new bracket at the factory.
Product # Product description Serial number Production month
D44917 PUNCH UNIT PU5020 NA 0001704223 ~ Dec 2012 ~
D44927 PUNCH UNIT PU5020 EU 0002701973 ~ Dec 2012 ~
D44928 PUNCH UNIT PU5020 SC 0002800124 ~ Dec 2012 ~
Old
New
To Next Page
Loading...
