Technical Bulletin PAGE: 1/1
Model: Taurus-C1a/C1b (D074/D075) Date: 08-Aug-12 No.: RD074085
Subject: Note on proper installation of the pressure roller
bearing
Prepared by: Shinnosuke Sasaki
From: 1st PP Tech Service Sec., PP Tech Service Dept.,
Classification:
Troubleshooting
Mechanical
Paper path
Product Safety
Part information
Electrical
Transmit/receive
Other ( )
Action required
Service manual revision
Retrofit information
Tier 2
This RTB has been issued to announce the following note regarding proper installation of
the bearing for the pressure roller in the fusing unit.
Make sure the pressure roller bearing is installed correctly. (See the diagrams below.)
Incorrect installation of the bearing could result in errors such as SC569 (Pressure Roller
Lift Error).
Correct
Incorrect
The flange is faced to the outside.
The flange is faced to the inside.
Pressure Roller
To Next Page
Loading...
