Technical Bulletin PAGE: 1/2
Reissued:24-Aug-11
Model:
Taurus-C1 (D074/D075)
Date:
19-Aug-11
No.:
RD074018a
RTB reissue
Notes in bold italics were revised.
Subject:
Request Regarding Reference Print Samples
from
RCL Factory
Prepared by:
K. Tsutsui
From:
PP Service Planning Department 1G
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Product Safety Other ( ) Tier 2
This RTB has been issued to make the following request regarding the print samples
included at the RCL factory as accessories to the Taurus.
Request
Please make sure all the print samples are collected after site installations and are NOT
left at customer sites. If not needed, you may discard the samples.
Background
These print samples are printed and packaged at the RCL factory, and they are supposed
to be used as a reference for checking initial image quality generated from units newly
installed.
Although this image check is not a mandatory process, you may do the check by referring
to the procedures on the following page if you are concerned with the initial image quality
observed from a newly installed unit.
To Next Page
Loading...
