Ricoh Taurus-C1a - RTB 141; Part for Chargge Roller Lever Replacement; SYMPTOM; CAUSE; SOLUTION

Technical Bulletin PAGE: 1/2
Model:
Taurus-C1/P1
Date:
7-May-18
No.:
RD074141
Subject:
Part for Charge Roller Lever Replacement
Prepared by:
H Kawamura
From: PPCS Section, CIP Product Quality Management Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Product Safety Other ( ) Tier 2 Tier 0.5
SYMPTOM
The Charge Roller Lever becomes damaged, requiring the replacement of the entire
PCDU assembly.
CAUSE
Inserting the PCDU into the machine without securing the Charge Roller Lever.
SOLUTION
Apply the Charge Roller lever on top of the broken part
Part Number : D1949100
Part Description : Charge Roller Lever
Note: This solution only works if the remaining part in the red circle is still in the PCDU
<Procedure for applying the part>
1. Pull out the affected PCDU
2. Turn the broken lever to the close position