Technical Bulletin PAGE: 2/2
Model: Taurus-C1/P1 (D074/D075/M044) Date: 18-Jul-12 No.: RD074080
Detail
A spring plate is attached to the black plastic plate to conduct electrical bias from the heat
sink to the development roller.
Removing this black plastic plate could bend the spring plate and disable proper contact
between the spring plate and the heat sink, resulting in the sharp bands at 50mm intervals
like the picture on P.1.
F
ront frame
Spring plate
Black plastic plate
D-
Frame
Spring-plate
Black plastic plate
This D-cut hole connects to
the development roller.
Front view of the PCDU,
with its cover removed
Black plastic plate
Normal
Bent
Black plastic plate
This photo shows an example of a bent spring pate.
To Next Page
Loading...
