T
echnical
B
ulletin PAGE: 2/2
Model:
Taurus-C1/P1 (D074/D075/M044)
Date:
24-Sep-12
No.:
RD074091
Procedure B
Maintain the settings made in the previous “Procedure A” and change the screen settings
on the Fiery controller (Job Properties – Image – Halftone Mode).
Change the default setting “200 Dot + Fine Text (1200dpi)” to one of the following and
check the results.
175 Dot (1200dpi)
150 Dot (1200dpi)
175 Line + Fine Text (1200dpi)
200 Dot (600dpi)
Note
1. The above settings are listed in the order of the effect the settings have on tone jump
(ineffective --> effective from top to bottom of the list). Generally, tone jump will
become less noticeable by applying a low resolution setting although with a trade-off in
image quality.
2. If the desired effect cannot be achieved, decrease the value applied in #203 (Adjust
Maximum Image Density) of the Skilled Operators Menu, execute #201 (Adjust Image
Density) and perform the color calibration on the Fiery controller. Note that this will
also lower the density of solid images and reduce the color gamut.
To Next Page
Loading...
