Technical Bulletin PAGE: 4/5
Model: Taurus-C1a/C1b (D074/D075) Date: 1-Oct-13 No.: RD074109
6. Remove the motor. (screw x2)
7. Remove the gear. (E-type retaining ring x1)
8. Remove the harness clamp.
9. Attach the new bracket to the punch unit by following the above steps in reverse order.
10. Install the punch unit with the new bracket on the finisher to complete the procedure.
See the following section of the service manual for the installation procedure:
2. Installation > Finishers (D512/D513) > Punch Unit PU5020 NA, EU, SC (D449-17, -27, -28)
To Next Page
Loading...
