Technical Bulletin PAGE: 4/4
Reissued:12-Feb-14
Model: Taurus-C1a/C1b (D074/D075)
Align the white marking on the coupling gear of the development unit with the white
marking on the mainframe gear by turning the coupling gear counterclockwise. If the
coupling gear is marked in white and pink, refer to the pink marking when aligning the
gears.
IMPORTANT: Turn the coupling gear of the development unit counterclockwise
viewed from the rear side.
Example
For example, if the white marking on the drive gear is at 8 o’clock viewed from the
front side, turn the coupling gear on the development unit counterclockwise so that
the marking on the coupling gear is at 4 o’clock viewed from the rear side of the
development unit.
The coupling gear is marked at the factory for each development unit. Matching these
markings with the markings on the drive gears enables the Development Roller to revolve
at the center of its axis, generating the best possible performance.
To Next Page
Loading...
