Ricoh Taurus-C1a - Page 477

Technical Bulletin PAGE: 25/25
Model: Taurus-C1a/C1b (D074/D075)
Date: 20-Mar-14
No.: RD074118
Procedure required after cleaning the ITB speed sensors
Make sure to perform the following procedure after cleaning the ITB speed sensors.
1. Execute SP2-912-001 (Encoder Sn:Adj Light: Adj Light Amt).
2. Turn the main switch off and then on.
3. Execute SP2-914-001 (Encoder Sn:Get 1stPhase: Get Phases: Execute All).
4. Turn the main switch off and then on.
5. Check the value of SP2-915-001 (Encoder Sn Ctrl Condition: Scale FB Control Enable)
 If the value is “1”, the feedback control is properly turned on.
 If the value is “0,” repeat the sensor cleaning procedure until the value is “1”.
6. Execute SP3011-4 (Manual ProCon: Exe: Full MUSIC) to complete the procedure.