Technical Bulletin PAGE: 2/2
How to attach the GUARD:INTERMEDIATE TRANSFER (p/n: D0743832)
1. Clean the surface of the COVER:INTERMEDIATE TRANSFER:NO.1 where the
guard attaches to with a cotton swab and alcohol.
2. Attach the guard to the edge of the cover as shown below.
3. Press the 4 edges of the guard for secure attachment with no air bubbles.
COVER:INTERMEDIATE TRANSFER:NO.1
GUARD:INTERMEDIATE TRANSFER
Tolerance: 0~0.5mm
from the cut in the corner
of the cover
Tolerance: 0.6~1.5mm
from the edge
Cut in the corner
of the cover
To Next Page
Loading...
