Technical Bulletin PAGE: 29/58
Model: Taurus-C1 / P1 Date: 21-Oct-11 No.: RD074026
< Right Drawer \ LCIT Relay Sensor 2 >
Change in screw quantity
Before the Revision After the Revision
2. Disconnect the sensor bracket [1] ( x1). 2. Disconnect the sensor bracket [1] ( x2).
< Right Drawer \ Double-Feed Sensor 1 (LED) >
Change in screw quantity
Before the Revision After the Revision
2. Remove bracket [1] ( x2). 2. Remove bracket [1] ( x1).
< Right Drawer \ Double-Feed Sensor 2 (Receptor) >
Correction of screw quantity and type
Before the Revision After the Revision
2. Disconnect the sensor bracket and remove the
sensor (
x2, x1).
2. Disconnect the sensor bracket and remove the
sensor ( x1, x1, x1).
< Fusing Unit \ Before You Begin... >
“WARNING” note was added.
• The fusing unit can become very hot during normal operation.
• Before removing the fusing unit, switch the machine off and wait at least 10 min. For the fusing unit
to cool so it can removed and handled safely.
To Next Page
Loading...
