Technical Bulletin PAGE: 32/58
Model: Taurus-C1 / P1 Date: 21-Oct-11 No.: RD074026
The following was added as a procedure required after replacement with a new hot roller.
After New Hot Roller Installation
A newly installed hot roller may have a tendency to catch and cause spurious noise. Do the following
procedure to avoid this problem.
1. Remove the top cover screws (
x2, x1).
2. Remove top cover [A].
3. Loosen screw [B] (
x1 M3x6).
4. Slide plate [A] to the rear.
5. Remove separation unit [B].
6. Lower the spring arm for position [A] to [B] as shown above.
To Next Page
Loading...
