Technical Bulletin PAGE: 48/58
Model: Taurus-C1 / P1 Date: 21-Oct-11 No.: RD074026
The following table was added in step 1 of “Procedure 4: Changing the process speed”,
<D075>:
Advanced Settings SP Code Settings
High 0: Target Speed
Middle 1: Medium Speed
Low 2: Low Speed
< Troubleshooting for Paper Delivery Problems\ Frequent Paper Misfeeds \ When
using thick paper or slippery paper. >
Before the Revision After the Revision
<If custom paper is used>
1. In [Advanced Settings] for the custom paper in
use, set [03: Pickup Assist Setting] to [On].
<If custom paper is not used>
1. In the [Adjustment Settings for Skilled Operators]
menu, set [0115: Pickup Assist Setting] to [On].
<If custom paper is used>
1. In [Advanced Settings] for the custom paper in
use, set [03: Pickup Assist Setting] to [On] or set
SP1-977 to "1: ON".
<If custom paper is not used>
1. In the [Adjustment Settings for Skilled Operators]
menu, set [0115: Pickup Assist Setting] to [On] or
by setting SP1-923-001 to 006 to "1: FORCE ON".
< Troubleshooting for Paper Delivery Problems\ Messages Reporting Paper
Misfeeds \ If (J032) Appears >
The description “Before Action” was deleted.
< Troubleshooting for Paper Delivery Problems\ Messages Reporting Paper
Misfeeds \ If (J033) or (J083) Appears >
The troubleshooting instructions for “J033” and “J083” were merged, and the following
introductory description was added:
At installation the service technician executes machine position adjustment using. If
the sub scan registration adjustment exceeds ±0.3 mm, the service technician should
inform the operator about the amount of adjustment and then guide the operator
through the user adjustment settings. The relevant settings are:
• Side 1 image position adjustment: Direction of paper feed
• Side 2 image adjustment: Direction of paper feed
< Troubleshooting for Paper Delivery Problems\ Messages Reporting Paper
Misfeeds \ If (J097) Appears >
Before the Revision After the Revision
Sheets of mixed t
e, thickness, or color are loaded Sheets of mixed t
e, thickness, or color are loaded
To Next Page
Loading...
