NOTICE!
Property damage as a result of tilting in synchro-
nous systems!
Impact loads can briefly overcome the self-locking on
the Multilift II impact, and cause tilting in the synchron-
ised group.
– If this case arises, carry out an initialisation run.
These variants are suitable for use in ESD work stations. Electro-
static discharges can be conducted away over the entire lifting
column.
The electrical connection of the lifting column profiles has a max-
imum resistance of 100 ohms.
NOTICE!
The plastic materials used on the Multilift II ESD/
telescope ESD lifting columns are not ESD-con-
ductive.
If the lifting column is connected to an overall system
(e.g. workstation), make sure that there is a guaran-
teed conductive connection between all components.
This can be ensured, for example, using ESD-compat-
ible assembly plates, foot versions and PA slot stones.
This variant is suitable for use in clean rooms.
A special cover on the lifting column's DC motor with brushes mini-
mises the ejection of particles.
Multilift II ESD/telescope ESD
Multilift II clean
Set-up and function
Function description > Function description - Multilift II
20.02.2019Lifting column Multilift I/Multilift II88
To Next Page
Loading...