RK Rose+Krieger Multilift I - Controller; Foot Versions

3.3.5 Foot versions
Fig. 11: Foot versions
A Foot version - type 1
B Foot version - type 2
C Foot version - type 3
D Foot version - type 4
E Foot version - type 5
F Foot version - type 6/7
G Foot version - type 8
Valid for Multilift I
Valid for Multilift II telescope/telescope ESD
Valid for Multilift II Standard/ESD/clean
Valid for Multilift II Impact
The feet (Fig. 11) are used to stabilise the lifting columns. Round
components on the feet can be used for additional alignment of the
lifting columns.
3.3.6 Controller
NOTICE!
Property damage as a result of using an incompa-
tible controller!
– Only use the RK Rose+Krieger GmbH controllers
listed in the table.
– If using controllers provided by the operator,
adhere to Ä Chapter 3.5 “Electrical connection to a
controller provided by the operator” on page 94.
The following RK Rose+Krieger GmbH controllers can be con-
nected to the lifting columns:
Multilift I/II
Incompatible controllers
Compatible controllers
Set-up and function
Optional modules > Controller
20.02.2019 Lifting column Multilift I/Multilift II 91