Rohde & Schwarz CMW500 - Page 264

Command Reference - Base Software
R&S
®
CMW500
248User Manual 1173.9463.02 ─ 06
Suffix:
<n>
.
1..3
Selects the pool entry to be configured or queried
Parameters:
<FirstSegment> First octet of the IP address, not configurable
Range: 0 to 255
<SecondSegment> Second octet of the IP address, not configurable
Range: 0 to 255
<NodeID> Third octet of the IP address
Range: 5 to 255
*RST: 5, 6, 7 for <n> = 1 to 3
<LocalID> Fourth octet of the IP address
Range: 1 to 254
*RST: 2
Example:
CONFigure:BASE:MMONitor:IPADdress3 1,1,10,50
Sets the third address of the pool to x.x.10.50. The first two octets
depend on the subnet configuration.
Firmware/Software: V3.0.10
6.3.10.7 IP Subnet Configuration
The following commands configure settings related to the IPv4 subnet the instrument
belongs to. The settings are also available in the "Misc > IP Subnet Config" section of the
"Setup" dialog.
SENSe:BASE:IPSet:SNODe:NNAMe?.............................................................................248
SENSe:BASE:IPSet:SNODe:NTYPe?..............................................................................249
CONFigure:BASE:IPSet:SNODe.....................................................................................249
SENSe:BASE:IPSet:SNODe:NSEGment?........................................................................249
CONFigure:BASE:IPSet:NWADapter<n>..........................................................................250
SYSTem:BASE:IPSet:SMONitor:REFResh.......................................................................250
SENSe:BASE:IPSet:SMONitor:NAME?............................................................................251
SENSe:BASE:IPSet:SMONitor:TYPE?.............................................................................251
SENSe:BASE:IPSet:SMONitor:ID?..................................................................................251
SENSe:BASE:IPSet:SMONitor:DESCription?....................................................................251
SENSe:BASE:IPSet:SNODe:NNAMe?
Queries the subnet node name of the R&S CMW500.
Return values:
<Name> Name as string
Usage: Query only
Firmware/Software: V3.0.10
Instrument-Control Commands