R&S
®
ZVA/ZVB/ZVT Trace Menu
1145.1084.12 4.47 E-6
Assign Channel is disabled if the current setup contains only one channel. To create an
additional channel, select Channel – Channel Select – New Channel.
Remote
control:
CALCulate<Ch>:PARameter:SDEFine <Trace Name>, < Meas
Parameter>
Assign Diag. Area
Assigns the active trace to another diagram area. A popup window offers a list of all areas available:
• Selecting one of the existing area numbers assigns the active trace to the existing diagram
area: The active trace is removed from the previous area and displayed in the new diagram
area.
• Selecting New creates a new diagram area and assigns the active trace to the new area. The
new area is numbered <n>, where <n> is the largest of all existing area numbers plus one.
Assign Diag. Area is disabled if the current setup contains only one area. To create an additional
area, click Display – Area Select – New Diag. Area.
To go to another diagram area and activate the last active trace in this area, simply click a point
inside the new area.
Remote control:
DISPlay:WINDow<Wnd>:TRACe<WndTr>:FEED <Trace Name>
Trace Manager
Opens a dialog to perform the actions in the Trace Select menu systematically for all traces and
diagram areas.
To Next Page
Loading...
