Display Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.240 E-6
To vary the size and position of the diagram areas, drag and drop the separating
frames, use the Split Manager or the functions of the Window menu.
Remote control:
No command, display configuration only.
Maximize
Maximizes all diagram areas of the active setup to occupy the whole window, placing the active diagram
area on top. While Maximize is selected Next Diag. Area or Select Diag. Area can be used to activate
and display the other diagram areas. The remaining commands of the Area Select submenu except
Title are disabled.
Clicking Maximize again restores the previous display configuration.
To Next Page
Loading...
