R&S
®
ZVA/ZVB/ZVT Remote Control: Introduction
1145.1084.12 5.5 E-1
Refer to the GPIB explorer's help system for more information.
Switchover to Remote Control
On power-up, the instrument is always in the manual operating state and can be operated via the front
panel controls. The instrument is switched to remote control as soon as it receives a command from the
controller. If the instrument is controlled via RSIB or VX 11 interface, the alternative commands @REM
and @LOC can be used to switch from manual to remote control and back.
While remote control is active, operation via the front panel is disabled with the exception of two
softkeys. The instrument settings are optimized for maximum measurement speed; the display is
switched off:
The two softkeys in the remote screen are used to modify or quit the remote state:
To Next Page
Loading...
