Rohde & Schwarz R&S ZVA 8 - Marker Tracking; Bandfilter

R&S
®
ZVA/ZVB/ZVT Trace Menu
1145.1084.12 4.99 E-6
Use the paste marker list for convenient entry of Start and Stop values.
Remote control:
CALCulate<Ch/Tr>:MARKer<Mk>:FUNCtion:DOMain:USER
CALCulate<Ch/Tr>:MARKer<Mk>:FUNCtion:DOMain:USER:STARt
CALCulate<Ch/Tr>:MARKer<Mk>:FUNCtion:DOMain:USER:STOP
Marker Tracking
Causes the active minimum/maximum or target search of the active marker to be repeated after each
sweep: When tracking mode is active the marker typically changes its horizontal and its vertical position
as the measurement goes on.
Tracking mode properties
The tracking mode is available for all search modes, i.e. for minimum/maximum search, target search
and bandfilter search. The Marker Tracking function in the Search submenu is valid for an active
minimum/maximum and target search; bandfilter tracking can be activated separately. Tracking is
marker-specific but can be switched on for several markers simultaneously.
Switching between Max Search and Min Search does not affect the tracking mode.Tracking is switched
off though when one of the following actions is performed:
• Redefinition of the active marker position by means of the functions in the Marker menu or
drag-and-drop of the active marker symbol.
• Change of the active marker's search mode, e.g. from a minimum/maximum search to a target
search.
Tracking is a toggle function: Selecting the function repeatedly switches the tracking mode on and off.
Remote control:
CALCulate<Ch/Tr>:MARKer<Mk>:SEARch:TRACking
Bandfilter
Opens a submenu to search for trace segments with a bandpass or bandstop shape and determine
characteristic filter parameters.
Bandfilter search and filter parameters
Bandpass and bandstop regions can be described with the same parameter set: