Front Panel Tour R&S
®
ZVB
1145.1055.62 1.2 E-2
Display
The analyzer is equipped with a color display providing all control elements for the measurements and
the diagram areas for the results.
• Refer to section Navigation Tools of the Screen in Chapter 3 to learn how to use menus, keys
and softkeys.
• Refer to section Display Elements in Chapter 3 to obtain information about the results in the
diagram area.
• Refer to section Display Menu in the online help system and learn how to customize the screen.
• Refer to the data sheet for the technical specifications of the display.
Disk Drive
A 3.5'' disk drive is located at the front panel of the analyzer.
The disk drive can be used for data transfer from and to the analyzer, in particular to do the
following:
• Store data files from the analyzer, e.g. store a setup to be used on another instrument or
at a later time.
• Load data files, e.g. calibration kits, memory traces, setups.
• Perform a firmware update (if the setup file can not be loaded from another storage
medium or a network connection).
Setup Keys
The keys in the TRACE, CHANNEL, DISPLAY, SYSTEM and SUPPORT keypads call up groups of
related measurement settings. Each key corresponds to a drop-down menu or menu command of the
graphical user interface.
The TRACE keys give access to all trace settings and the functions to
select, modify and store different traces. In addition the menu provides the
marker, search and limit check functions.
• MEAS selects the quantity to be measured and displayed.
• FORMAT defines how the measured data is presented in the graphical
display.
• SCALE defines how the current trace is presented in the diagram
selected in the Format submenu.
• TRACE SELECT provides functions to handle traces and diagram areas,
and assign traces to channels.
• LINES defines limits for measured values and activates the limit check.
• TRACE FUNCT(ions) store traces to the memory and perform
mathematical operations on traces.
To Next Page
Loading...
