Rohde & Schwarz R&S ZVA 8 - Remote Desktop Connection

R&S
®
ZVA Remote Control in a LAN
1145.1090.62 1.21 E-1
Manual TCP/IP configuration
To disable dynamic TCP/IP configuration and enter the TCP/IP address information manually proceed
as follows:
1. Obtain the IP address and subnet mask for the analyzer and the IP address for the local default
gateway from your network administrator. If needed, also obtain the name of your DNS domain
and the IP addresses of the DNS and WINS servers on your network. If you use both LAN
connectors, you need two different sets of address information.
2. Press the Windows key to access Windows XP Embedded.
3. Open the Control Panel – Network Connections – Local Area Connection Status – Local Area
Connection Properties – Internet Protocol (TCP/IP) Properties dialog and enter the address
information, e.g.:
For more information refer to the Windows XP Embedded Help.
Remote Desktop Connection
Remote Desktop is a Windows application which can be used to access and control the analyzer from a
remote computer through a LAN connection. While the measurement is running, the analyzer screen
contents are displayed on the remote computer, and Remote Desktop provides access to all of the
applications, files, and network resources of the analyzer.
To set up a Remote Desktop connection
1. Connect the analyzer to a LAN and determine its IP address; see Remote Control in a LAN.
2. Set up your remote computer (integrated in the LAN) to use Remote Desktop and create the
Remote Desktop connection to the analyzer.
For detailed information about Remote Desktop and the connection refer to the Windows XP
Embedded Help.