R&S
®
ZVB Windows XP Embedded
1145.1055.62 1.21 E-2
Windows XP Embedded
The analyzer is equipped with a Windows XP Embedded operating system which has been configured
according to the instrument's features and needs. Changes in the system configuration can be
necessary in order to
• Establish a LAN connection
• Customize the properties of the external accessories connected to the analyzer
• Call up additional software tools
Attention!
The operating system is adapted to the network analyzer. To avoid impairment of
instrument functions, only change the settings described in this manual. Existing
software must be modified only with update software released by Rohde &
Schwarz. Likewise, only programs authorized by Rohde & Schwarz for use on the
instrument must be executed.
The Start menu of the operating system is accessed by pressing the Windows key in the SUPPORT
keypad. All necessary settings can be accessed from the Start menu, in particular from the Control
Panel.
Firmware Update
Upgrade versions of the analyzer firmware are supplied as single setup files *.msi. To perform a
firmware update
1. Copy the setup file to any storage medium accessible from the analyzer. This may be the
internal hard disk, an external storage medium (USB memory stick, CD-ROM with external
drive) or a network connection (LAN, IEEE bus).
2. Double-click the setup file (or use the front panel keys to select and start the setup file; see
Using Front Panel Keys in Chapter 2) and follow the instructions of the setup wizard.
Setup files can be stored and installed again. The default drive name of the internal hard disk is C:.
External storage devices are automatically mapped to the next free drive, i.e. D:, E: etc.
Attention!
The Calibration Unit (accessory R&S ZV-Z51) must be disconnected during a
firmware update.
To Next Page
Loading...
