Rohde & Schwarz R&S ZVA 8 - Display Configuration; Data Transfer

Simple Measurement Tasks R&S
®
ZVA/ZVB/ZVT
1145.1084.12 9.2 E-4
Display Configuration
The analyzer provides various tools that you can use to customize the diagram areas and control
elements. The following examples show how to change the display colors.
To select or define a color scheme for the diagrams and their display elements...
1. Click Display — Display Config — Color Scheme... to open the Color Scheme dialog.
2. Select the Predefined Scheme that is most appropriate for your needs.
3. Click Define User Scheme... to open the Define User Color Scheme dialog.
4. Select a display element from the Element drop-down list.
5. Click the Color field to open a standard Color dialog and assign the color.
You can repeat the last 2 steps for as many elements as you like. For traces, you can also select a
Trace Style and Trace Width. Your settings apply to all setups, they are permanent even after you close
the network analyzer application.
6. If you wish to use several color schemes in parallel, click Save to save your current color
scheme to a file.
7. If you wish to restore the original Predefined Scheme, click System — System Config... —
Resets — Reset Colors.
To change the marker colors...
When you create markers, their color is the same as the color of the associated trace. You can change
the marker colors using the Color Scheme dialog.
1. Click Display — Display Config — Color Scheme...
2. Click Define User Scheme... to open the Define User Color Scheme dialog.
3. Select Same Color for all Markers from the Element drop-down list.
4. Click the Color field to open a standard Color dialog and assign the color.
5. Click Use same Color for all Markers.
All markers are displayed with the same color, irrespective of the trace colors.
Data Transfer
The following examples show you how to perform basic tasks related to data transfer from and to the
analyzer.
To copy the active setup ...
1. Insert a floppy disk into the disk drive.
2. Click File — Save to open the Save As dialog.
3. Open the Save in: drop-down list and select disk drive A (labeled 3 1/2 Floppy (A)) as file
location.