Rohde & Schwarz R&S ZVA 8 - Add Channel + Trace; Add Channel + Trace + Diag. Area; Delete Channel

R&S
®
ZVA/ZVB/ZVT Channel Menu
1145.1084.12 4.195 E-6
Add Channel + Trace
Creates a new channel and a new trace, which is displayed in the active diagram area. The new
channel settings (including a possible channel calibration) are identical to the previous channel settings;
the trace is created with the trace settings of the former active trace but displayed with another color.
The former and the new active trace are superimposed but can be easily separated, e.g. by changing
the Reference Position.
The new channel is named Ch<n>, where <n> is the largest of all existing channel numbers plus one.
The name can be changed in the Channel Manager.
To create a new trace in the active channel, use the Trace – Traces – Add Trace function. To
create a new channel and a new trace and display it in a new diagram area, use Add Channel + Trace
+ Diag. Area.
Remote control:
CONFigure:CHANnel<Ch>[:STATe] ON
CALCulate<Ch>:PARameter:SDEFine "<Trc_name>", "<Parameter>"
DISPlay:WINDow<No>:TRACe:FEED "<Trc_name>"
Add Channel + Trace + Diag. Area
Creates a new channel and a new trace, which is displayed in a new diagram area. The new channel
settings (including a possible channel calibration) are identical to the previous channel settings; the
trace is created with the trace settings of the former active trace but displayed with another color.
The new channel is named Ch<n>, where <n> is the largest of all existing channel numbers plus one.
The name can be changed in the Channel Manager.
To create a new trace in the active channel, use the Trace – Traces – Add Trace function. To
create a new channel and a new trace and display it in the active diagram area, use Add Channel +
Trace.
Remote control:
CONFigure:CHANnel<Ch>[:STATe] ON
CALCulate<Ch>:PARameter:SDEFine "<Trc_name>", "<Parameter>"
DISPlay:WINDow<No>:STATe ON
DISPlay:WINDow<No>:TRACe:FEED "<Trc_name>"
Delete Channel
Deletes the current channel including all traces assigned to the channel and removes all display
elements related to the channel from the diagram area. Delete Channel is disabled if the setup contains
only one channel: In manual control, each setup must contain at least one diagram area with one
channel and one trace.
To restore a channel that was unintentionally deleted, use the Undo function.
Remote control:
CONFigure:CHANnel<Ch>[:STATe] OFF