R&S
®
ZVA/ZVB/ZVT Trace Menu
1145.1084.12 4.93 E-6
• Max Search sets the active marker to the absolute maximum in the search range.
• Min Search sets the active marker to the absolute minimum in the search range.
• Next Peak sets the active marker to the next maximum or minimum in the search range,
depending on the current search criterion.
• Peak Search > sets the active marker to the next peak with higher stimulus value.
• < Peak Search sets the active marker to the next peak with lower stimulus value.
• Target opens a submenu to search for a specific value on the trace.
• Marker Tracking causes the search to be repeated after each sweep.
• Bandfilter opens a submenu to search for trace segments with characteristic bandfilter shape
and calculate the filter parameters.
• Define Peak defines the criteria for the peak search.
• Search Range... assigns a search range to each marker of the current trace.
The search functions are available in all Cartesian and polar diagram types (see Trace – Format).
In polar diagrams (Polar, Smith, Inverted Smith), where complex values are displayed, the magnitude of
the response values provides the search criterion.
Max Search
Sets the active marker to the absolute maximum in the search range, i.e. to the largest of all response
values. If a complex trace format (e.g. a polar diagram) is active, the marker is set to the measurement
point with the maximum magnitude.
By default the search range coincides with the sweep range. If the active trace contains no markers, a
marker Mkr 1 is created to indicate the search result.
To Next Page
Loading...
