Connecting External Accessories R&S
®
ZVT
1300.0045.62 1.12 E-1
printer driver is installed. If required, printer driver installation is initiated using Windows XP's Add
Printer Wizard. The wizard is self-explanatory. A printer driver needs to be installed only once, even
though the printer may be temporarily removed from the analyzer.
Printer driver installation
A great variety of printer drivers is available on the analyzer. To obtain the complete list, access
Windows XP (press the Windows key) and open the Add Printer Wizard in the Start – Control Panel –
Printer and Faxes menu.
You can load updated and improved driver versions or new drivers from an installation disk, USB
memory stick or another external storage medium. Alternatively, if the analyzer is integrated in a
network, you can install driver data stored in a network directory. In either case, use the Add Printer
Wizard to complete the installation.
Use the Page Setup dialog or the Start – Control Panel – Printers and Faxes menu of Windows
XP to configure the printer properties. To access Windows XP, press the Windows key on the external
keyboard or on the hardkey bar of the GUI; see section Connecting a Monitor on p. 1.12.
Connecting a Monitor
A standard VGA monitor can be connected to the 15-pole Sub-Min-D MONITOR connector on the rear
panel of the analyzer.
Attention!
The monitor must be connected while the instrument is switched off (in standby
mode). Otherwise correct operation can not be guaranteed.
The monitor displays the magnified Graphical User Interface (GUI) with all diagram areas,
measurement results and control elements.
With an additional mouse or keyboard connected to the analyzer, you can control the
measurement from the external monitor. The GUI contains the Hardkey Bar with key shortcuts for the
most important menus and submenus.
Connecting a LAN Cable
A LAN cable can be connected to one of the LAN connectors on the rear panel of the analyzer. To
To Next Page
Loading...
