R&S
®
ZVA/ZVB/ZVT Channel Menu
1145.1084.12 4.151 E-6
• Port Config... calls up a dialog to define the properties of the test ports, the source and the
receiver.
• Harmonic Distortion opens a submenu providing arbitrary harmonic measurements.
• Mixer Mode opens a submenu to control the measurement of the mixing products generated by
an external mixer that is supplied with two independent RF signals.
• Virtual Transform opens a submenu to define the parameters of a virtual matching network to
be embedded into/deembedded from the measurement circuit for a DUT with single ended or
balanced ports.
• Alternating Sweeps activates or deactivates the operating mode where the analyzer performs
only one partial measurement per sweep.
• Spurious Avoidance opens a submenu to define the relative position of the local oscillator (LO)
relative to the RF input signal.
• ALC (All Chans) enables or disables the Automatic Level Control for all channels.
• Low Phase Noise reduces the phase noise of the source signals.
Port Configuration
The Port Configuration dialog defines the properties of the test ports and configures the source signals
and the receiver.
To Next Page
Loading...
