R&S
®
ZVA/ZVB/ZVT Trace Menu
1145.1084.12 4.97 E-6
Search Range...
Opens the Search Range Dialog to confine the target search to a subrange of the sweep.
Define Peak
Opens a dialog to define the peak type to be searched for.
It is possible to select the peak type up to ten times for each trace and assign the selection to the
markers no. 1 to 10.
• Marker Selects one of the ten markers that can be assigned to the trace. If a selected marker
does not exist, it is created as soon as On is checked. A created marker is displayed in the
center of the search range.
The radio buttons in the Peak Type panel offer the following alternative peak types:
• Local Max activates the peak search for local maxima only. The response value at a local
maximum is larger than the values in the vicinity.
• Local Min activates the peak search for local minima only. The response value at a local
minimum is smaller than the values in the vicinity.
• Local Min or Max activates the peak search for both local maxima and minima.
Search Range
Opens the Search Range Dialog to confine the minimum/maximum search to a subrange of the sweep.
Search Range Dialog
Defines search ranges for the maximum/minimum or target search.
To Next Page
Loading...
