R&S
®
ZVB Front Panel Tour
1145.1055.62 1.3 E-2
• MARKER positions markers on a trace, configures their properties and
selects the format of the numerical readout.
• SEARCH uses markers to locate specific points on the trace.
• MARKER FUNCT(ions) define the sweep range, scale the diagram and
introduce an electrical length offset using the active marker.
The CHANNEL keys give access to all channel settings and the functions to
activate, modify and store different channels.
• START CENTER or STOP SPAN define the sweep range, depending on
the sweep type.
• POWER BW AVG defines the power of the internal signal source, sets
the step attenuators and the IF bandwidths, and configures the sweep
average.
• SWEEP defines the scope of measurement, including the sweep type,
the trigger conditions and the periodicity of the measurement.
• MODE opens the Port Configuration dialog to define the properties of the
physical and logical (balanced) test ports.
• CHAN SELECT provides functions to handle and activate channels.
• CAL provides all functions that are necessary to perform a system error
correction (calibration).
• OFFSET provides a selection of length offset parameters to shift the
measurement plane.
The DISPLAY keys give access to all display settings and to the functions to
activate, modify and arrange different diagram areas.
• AREA SELECT provides functions to create and delete diagram areas
and select an area as the active area.
• DISPLAY CONFIG provides functions to arrange traces to diagram
areas, arrange the diagram areas in the active window and configure the
screen and the diagram areas.
The SYSTEM keys give access to the functions to return to a defined
instrument state and select general system settings.
• PRESET performs a general factory preset or user preset.
• SYSTEM CONFIG selects general system settings which do not only
apply to a particular setup.
A second group of keys (uncolored) provides standard Windows™
functions to save, recall or print setups and call up the measurement
wizard.
• SAVE saves an opened setup to a specific file.
• RECALL recalls an existing setup from a file.
• PRINT prints a setup.
To Next Page
Loading...
