Remote Control: Introduction R&S
®
ZVA/ZVB/ZVT
1145.1084.12 5.4 E-1
The following options are provided:
• NT named pipe (not supported at present)
• GPIB address (for connection to controllers equipped with a National Instrument GPIB interface
using the GPIB bus connector)
• RSIB address (for LAN connection, requires an appropriate IP or local host address; see LAN
Connection sections in Chapter 1)
• Socket interface (not supported at present)
• Named pipe A/B (only for local connection on the analyzer, recommended for remote test on
the instrument)
Select Info – Setup Info to look up the IP address information of your analyzer.
After the connection is established, the GPIB explorer displays a tree view of all commands included
in the current firmware version of the network analyzer. The programs can be selected for execution
by a single mouse click.
To Next Page
Loading...
