R&S
®
ZVA/ZVB/ZVT Channel Menu
1145.1084.12 4.219 E-6
The Calibration Kits dialog contains a series of buttons, each of them opening a dialog:
• Import Kit imports a cal kit file containing the parameters for a new calibration kit. It is possible
to load several kits, so the analyzer asks whether to set the imported calibration kit active.
• Add Kit combines different standards to form a new calibration kit.
• View/ Modify Kit adds or deletes standards in an imported or user-defined calibration kit and/or
changes their parameters.
• Delete Kit removes an imported or user-defined kit from the list of Calibration Kits in Use.
• Export Kit exports calibration kit data to a cal kit file.
• Connector Types adds or deletes connector types.
The Calibration Kits in Use: table is used to select a calibration kit for each connector type. The pull-
down lists contain all kits for the individual connector types.
Remote control:
[SENSe<Ch>:]CORRection:CKIT:<conn_type>:SELect "<Ckit_Name>"
Cal Kit Parameter Types
The analyzer uses three types of parameters to describe the calibration standards. The parameter type
is the same for all standards in a kit and therefore annexed to the kit name:
• Universal parameters (no label) describe calibration kit models with highly standardized
components so that the parameters are valid for all calibration kits of the model.
• Typical parameters (labelled typical) approximately describe a calibration kit model. To
correct for deviations between the standards, each kit of the model is individually measured and
delivered with an additional, kit-specific parameter set. Therefore each typical parameter set
<kit_name> typical is complemented by an additional parameter set <kit_name> containing
optimized parameters for an individual kit.
To Next Page
Loading...
