Rohde & Schwarz R&S ZVA 8 - Page 463

R&S
®
ZVA/ZVB/ZVT Common Commands
1145.1084.12 6.1 E-6
6 Command Tables
This chapter lists all common commands and SCPI commands implemented by the analyzer.
Common Commands
Common commands are taken from the IEEE 488.2 (IEC 625-2) standard. These commands have the
same effect on different devices. The headers of these commands consist of "*" followed by three
letters. Many common commands are related to the status reporting system.
COMMAND PARAMETERS UNIT REMARK
*CAL?
Calibration Query;
query only
*CLS
Clear Status;
no query
*ESE
0...255 Event Status Enable
*ESR?
Standard Event Status Query;
query only
*IDN?
Identification Query;
query only
*IST?
Individual Status Query;
query only
*OPC
Operation Complete
*OPT?
Option Identification Query;
query only
*PCB
0...30 Pass Control Back;
no query
*PRE
0...255 Parallel Poll Register Enable
*PSC
0 | 1 Power On Status Clear
*RST
Reset;
no query
*SRE
0...255 Service Request Enable
*STB?
Status Byte Query;
query only
*TRG
Trigger;
no query
*TST?
Self Test Query;
query only
*WAI
Wait to continue;
no query