Rohde & Schwarz Scope Rider RTH1004 - Page 105

Mask Testing
R&S
®
Scope Rider RTH
105User Manual 1326.1578.02 ─ 12
Figure 5-2: Mask settings
Reset all Mask Results
Resets all mask test results.
Remote command:
MASK:RST on page 349
Coupling
If enabled, the settings of the selected mask are applied to all active masks when you
tap "Create Mask".
Mask Channel
Selects the mask to be configured.
If the selected mask has been created before, and it is active, the mask is shown on
the display.
Each mask channel is assigned to its related waveform (input channel or math wave-
form) as indicated by the mask channel name.
State
Turns the mask on or off.
If the assigned waveform is inactive, it is activated together with the mask.
Remote command:
MASK:CHANnel<m>:STATe on page 348
Mask Settings